Our Services
Hob Installation
About This Service
Hob Installation Done Right
Our three-step process means every Hob Installation is surveyed, installed and safety-checked for compliance and convenience. First we carry out a site survey to confirm model, cut-out and whether gas or electrical work is required. Next our Gas Safe or FGas engineers make the connections, secure seals and fit trims. Finally we test, certify and leave you with operating guidance and paperwork.
Why Choose us for Hob Installation?
Qualified, accredited engineers
Gas Safe registered and FGas qualified technicians handle each install, with Ideal heat pump and boiler accreditation on the wider team for added reassurance.
Nearly 20 years of local experience
Based in Bedford with almost two decades experience in the trade, the team completes installs correctly first time and understands common UK kitchen layouts and constraints.
Transparent pricing and tidy finish
Clear upfront quotes, neat sealing and finishing around the hob cut-out, and a certified handover so you know exactly what was done and why.
Long-Term Savings
High-quality installations reduce the likelihood of costly repairs and premature replacements.
How It Works
Site Survey
We check the hob model, worktop cut-out, ventilation and whether a new gas or electrical supply is needed, then confirm access and any extra work.
Qualified Installation
A Gas Safe engineer fits gas hobs and makes tight, pressure-tested connections. FGas or qualified electricians handle electric and induction hobs and wiring.
Testing and Handover
We run pressure, leak and electrical tests, register or document the work where required and leave clear operating guidance plus certification.
Frequently Asked Questions
Yes. We fit gas, electric ceramic and induction hobs. Gas installations are completed by Gas Safe engineers and electrical work by FGas or qualified electricians, ensuring every installation meets the correct safety standards.
Sometimes. Our site survey identifies whether the existing gas pipe, isolation valve or worktop cut-out needs modification. We discuss any additional work and provide an upfront quote before starting the job.
Yes. All gas work receives the appropriate Gas Safe documentation and records. Electrical installations get the required electrical test documentation where applicable, and we always leave a clear handover and operating guidance.
Most straightforward installs complete in a single visit, but timing depends on worktop access, whether pipework or wiring needs altering and any ventilation work. The survey sets an accurate timescale and we confirm this when quoting.
We can relocate gas points and advise on ventilation, but these changes require a full site assessment. If moving supplies or adding vents is needed we include that work in the quote and carry out all tests and certifications afterwards.